Wanted
Austin 12 rolling chassis preferably with engine & gearbox for apprentices to strip and rebuild for training purposes.
There is so much training in an Austin 12 - side valve, magneto, cable brakes, clutch lining on flywheel not driven plate, cloth coupling, front brakes design through kingpins - the list goes on.
Looking for a donation ideally as in all education funds are limited.
This is a very worthy cause.
I’m sure between the many club members we could get together enough parts to get a project like this going.
I have a front & rear axle which I would be happy to donate as a starter.
Rolling Chassis wanted for Apprentice Training.
-
- Posts: 55
- Joined: Fri Nov 11, 2016 3:43 pm
- Location: Dumbleton, Worcestershire
- Contact:
Rolling Chassis wanted for Apprentice Training.
- Attachments
-
- 0CAAFE3C-C5F0-4938-892D-28A0DA42BD9C.jpeg (1.49 MiB) Viewed 1614 times
Measure twice -Cut once!
-
- Site Admin
- Posts: 43
- Joined: Mon Feb 19, 2018 11:26 pm
- Contact:
Re: Rolling Chassis wanted for Apprentice Training.
There has been an offer of £250 to get things started.
-
- Posts: 55
- Joined: Fri Nov 11, 2016 3:43 pm
- Location: Dumbleton, Worcestershire
- Contact:
Re: Rolling Chassis wanted for Apprentice Training.
I would be happy to donate a complete front & rear axle.
Measure twice -Cut once!